Velleman Kits & Projects

ABS enclosure, suitable for housing small electronic projects. The box has vertical grooves on the inside to allow for the securing of PCB's. All boxes supplied with lids, which are retained by 4 metric pozi head screws.

ABS enclosure which has vertical grooves on the inside to allow for the securing of PCB's. A plastic case which can be easily drilled or punched, lids are retained by self tapping screws.

These enclosures are manufactured from high impact dark grey ABS. The lid and the base are equipped with a tongue and groove sealing system with a neoprene gasket. The mounting holes and the lid fixing screws are located outside the seal area, preventing the ingress of moisture and dust. Internal guide slots allow the vertical mounting of printed circuit boards. The bosses on the internal base allow the horizontal fixing of PCB's or for the connection of terminals etc.

Ideally suited for instrumentation and telecommunication equipment, from hand held applications to lab and desktop sizes. Moulded in a high impact fire retardant dark grey ABS (UL94-VO). The G400 range of cases are moulded in plastic and have a two piece design. The tongue and groove joint between the top and bottom half offers environmental sealing to IP54 rating. The top and bottom case are lightly relived, creating a non scratch surface with a high quality finish. Guide slots are provided for vertical PCB mounting and internal bosses make horizontal PCB mounting possible.

This enclosure was originally designed to house projects manufactured by Velleman, but can be used to house any small PCB, Relay or PSU. It has as a pre-drilled top for LED's or making internal adjustments to pots etc. The case can be used free standing or mounted on standard DIN Rail.

This housing is suitable for Velleman K5600R (Red) Advertisement LED Display.

The housing is suitable for Velleman Domotica Light System K8006 It can accommodate busprint board and up to five plug-in units. It is also suitable for Velleman WSRC8056, K8056, K8090, VM118, VM129 and WMI8090, VM8090

These attractively styled enclosures were especially designed for "hand-held" instruments. The cases are in scratch-resistant ABS. The case parts are joined using 2/4 self-tapping screws.

The enclosures are manufactured from ABS or high-impact polystyrene and are available with a front panel in either aluminium or plastic.
A polystyrene enclosure with a vented cover and base. Front and rear panels in 1mm-thick aluminium. Each half shell has integral PCB guides and mounting studs. Matt surface finish. Eight screws close the housing. Max PCB size: 170 x 162mm