Velleman Kits & Projects

This stackable shield makes semi-permanent prototyping simple. When you want something more permanent than a breadboard, but don't want to make your own PCB, this shield is the answer. Provides solder-pads access to all of the Arduino's pins, and a large area of isolated pads.

The Velbus 1-channel 500W dimmer suitable for halogen lamps and lamps connected using a conventional transformer (block, toroid). Create an atmosphere which suits you best or let your lights dim slowly to avoid unexpected surprises. It is also possible to simulate a sunrise which makes waking up a lot more pleasant! Additional software to up grade and improve this product is available from the Velleman support section on the website.

The Velbus VMB1LED is a single channel dimmer and has been designed to dim LED lighting, integrates with the full range of the Velleman Velbus hone automation system.

VMB1RS is a small interface module designed to control the Velbus Home Automation System from a PC or Lap top. The module derives it's power from the velbus system. Full operating software is provided or can be down loaded here Velbus Software

The Velbus VMB1RY is a single channel relay which has been designed to switch resistive or inductive loads. It has suppressed voltage free relay contacts. The VMB1RY module features manual override control, can be controlled be several push buttons connected in parallel and can interface with the Velbus Home Automation System. VMB1RY has 16 possible time settings: moment - 5s - 10s - 15s - 30s - 1min - 2 min - 5min - 10min - 15min - 30min - 1h - 2h - 5h - 1day - on/off and 9 possible time settings for timer 2: 5min - 10min - 15min - 30min - 1h - 2h - 5h - 1day - on/off. The device can be programmed with or without the aid of a PC, using a unique simple learning process. All settings are stored and will not be lost in the event of a power failure. There are up to 248 possible address for each module, indication of output status (On/Off), power and data are displayed on LED's

Miniature Velbus relay for universal use.
If you have limited space to add a Velbus system relay, then this full featured relay is perfect. It has all the features of the bigger versions! One normal open relay contact, four virtual relays. Used for Velbus system, configurable via free Velbuslink software (V9.1 or higher) and USB/RS232 interface module, electronic addressable (up to 250 addresses), different operation modes: moment, on/off, timers, delayed on, … Free programmable timers. Firmware upgradeable through the Velbus system

2-channel 8A-12V/24V LED dimmer for dimming eg. LED strips. 0-10V controlled via VMB4DC

4-channel 0(1)-10V control. Can be used to control fixtures or dimmers (eg. VMB2LEDDC dimmer for LED strips, and Finder® 15.11.8.230.0400, Niko® 330-00701 or other 0-10V controlled universal dimmer for mains lamps).

Hand held remote control and codelock transmitter. 4 channels under your thumb!